There was a time when "Made in the USA" meant elegantly-styled field guns. These are our former shooting editor's top picks The post The Classic American Shotguns You Should Definitely Recognize appeared first on Outdoor Life.
Congressional researchers say the Supreme Court’s Hemani decision may reach beyond the marijuana gun ban and prompt lawmakers to examine other federal prohibited-person laws.
AK and SKS owners can save 22% on 500 rounds of PMC Bronze 7.62x39mm brass-cased FMJ. Code Aland5 drops the price to $391.58—about 78 cents per round.
The Third Circuit ruled 10-5 that New Jersey's semi-automatic rifle ban and 10-round magazine limit violate the Second Amendment. What it changes, and what it doesn't.
CINCINNATI, OH — Four of the biggest names in Second Amendment advocacy just asked a federal appeals court to do something no circuit has done: hold that the National Firearms Act’s registration scheme for short-barreled rifles violates the Constitution. The National Rifle Association, Fi...
An en banc Third Circuit ruling invalidates New Jersey’s ban on semiautomatic rifles and magazines holding more than ten rounds. The decision creates the federal appellate split the Supreme Court will confront in Viramontes and Grant.
Ed Monk broke down how to counter an active shooter with a handgun. Recap, key lessons, and how to watch the full webinar recording.
Most gun belts fail in the same place. The closure, where load concentrates and years of cinching eventually work slop into a belt that was supposed to stay rigid. Safariland and Haley Strategic Partners built the BASELINE system specifically around that problem, and the result is two belt models...
Platform selection for concealment, the holster and print-management realities that separate a workable off-duty setup from one that stays in a drawer, and the mindset differences that matter more than the hardware when an off-duty officer encounters a threat.
Welcome back to another edition of Concealed Carry Corner. Last week, we discussed the basics of printing and how to avoid printing. If you happened to miss that article, be sure to click the link here to check it out. This week, I want to take a closer look at some of the unique challenges...